Enrolling Printers

Funnel Beta only supports Asiga printers running Beta firmware.

This Beta firmware should have been linked in the email inviting you to the Beta test. If you no longer have that link you can contact us on funnel-support@asiga.com and get the link resent.

Beta firmware is a special release and will be one of the following versions:

• 2026-06-03-Max-Pro4K (available at Wetransfer)
• 2026-06-03-Ultra-Max2 (available at Wetransfer)

Prefer the latest versions. If you have issues with the latest firmware you can always go back to a previous version.

Installing the firmware

The Firmware will need to be installed on each printer you wish to use with Funnel.

If you need guidance on installing and updating your printer firmware, please refer to this instructional video: https://support.asiga.com/quick-tip/#updating-printer-firmware.

Connecting to the Funnel

In order to add your machines to the funnel, you will need to:

• make sure the printers have an internet connection
• you have access to the printer screen.

Step 1: Obtaining an Authorisation Code

Navigate to the funnel connectivity menu

For the Pro 4K and Max it is Settings > Funnel Connectivity

For the Max 2 & Ultra it is Settings > General > Connectivity

Step 2: Linking the printer to your organisation

Scan the QR code with your mobile device or login to the funnel, select add device from the devices page and enter the authentication code shown on the printer. You can also use the address https://auth.asiga.com/activate or use the ‘add device’ button on the devices page of your funnel account which opens up the same address.

If you are not logged in to your Asiga funnel account, you will be asked to login. If you do not have an account yet, you will be asked to create one.

The code is valid for 15 minutes, you can request a new one on the printer if it expires.

When the printer has been successfully linked to your funnel organisation, the printer screen will update to confirm it has been connected.